Hello everyone, many people are very distressed when their IGET BAR runs out of power. They can still smoke 300-400 times but it runs out of power. Today I will write a graphic introduction on how to charge the iget bar, I hope it can help you
Table of Contents
Step 1:A Charging Cable
Take a rechargeable charging cable, and after confirming that it can be charged, use scissors to cut the charging cable. And cut the insulating rubber wrapped around the charging cable.
After cutting the insulating rubber, you will see several wires. The red positive wire and the blue positive wire are what we will use next.
Step 2: Open and Remove IGET Bar
Use pliers or other tools to carefully open the cover of the iget bar from the bottom.After opening the cover at the bottom of the iget bar, let the cover fall naturally and complete the next step.
Next, use pliers or other tools to remove the host from the iget bar.
And gently remove the battery and other components by hand
After removing the battery and other components, there will be two parts left inside. We need to use tools to remove them and put the parts back in place.
After installing the two components back, pull out the metal rod at the bottom of the battery that is inserted into the e-liquid, and the corresponding pre-charging steps have basically been completed.
Step 3: Charge the IGET BAR
Use the previously processed charging cable, select the red and blue wires. Use glue to stick the red wire on the positive pole of the charging cable and the blue wire on the negative pole.The charging time is about 2-5 minutes. After charging, reinstall the battery and e-liquid according to the previous steps.Try to suck, if there is no problem, the charging process of iget is completed.
Warn
This will certainly allow you to take a few more puffs, but it is not particularly safe. I suggest you buy another one. IGET bar Australia store looks forward to your visit.